Electro-pneumatic action 3744312 224964297 2008-07-11T05:49:28Z Lightbot 7178666 Units/dates/other {{references|date=June 2008}} The '''electro-pneumatic action''' is a control system for [[pipe organ]]s, whereby air [[pressure]], controlled by an [[electric current]] and operated by the keys of an [[organ console]], opens and closes valves within wind chests, allowing the [[organ pipe|pipes]] to speak. This system also allows the console to be physically detached from the organ itself. The only connection was via an electrical cable from the console to the relay, with some early organ consoles utilizing a separate wind supply to operate combination pistons. == Invention == Although early experiments with Barker lever, tubular-pneumatic and electro-pneumatic actions date as far back as the 1850s, credit for a feasible design is generally given to the English [[organist]] and [[inventor]], [[Robert Hope-Jones]]. He overcame the difficulties inherent in earlier designs by including a rotating centrifugal air blower and replacing banks of batteries with a DC [[electric generator|generator]], which provided electrical power to the organ and drove the blower. This allowed the construction of new pipe organs without any physical linkages whatsoever. Previous organs all used [[tracker action]], which requires a mechanical linkage between the console and the organ. == Operation == When the organist selects a [[organ stop|stop]] and depresses a key, an electric circuit is completed, causing a low-voltage current to flow from depressed key, through the stop-tab switch, and on through the cable to the electro-pneumatic relay. The relay interprets the command from the console and sends an electric current to the appropriate [[solenoid]]. The solenoid is energized, causing the pipe valve connected to it to open, which emits compressed air into the pipe, allowing the pipe to speak. == Drawbacks == A drawback to the system was in the large amount of wiring required for operation. With each stop tab and key being wired, the transmission cable could easily contain several hundred wires. The great number of wires required between the relay and the organ itself, with each solenoid requiring its own signal wire, made the situation worse, especially if a wire was broken (this was particularly true with consoles located on lifts and/or turntables), which made tracing the break very difficult. These problems increased with the size of the instrument, and it would not be unusual for a particular organ to contain over a hundred miles of wiring. The largest pipe organ in the world, the [[Boardwalk Hall Auditorium Organ]], is said to contain more than 137,500 miles of wire. Modern electronic switching has largely overcome these physical problems. Many consider tracker action organs to be more sensitive to the player's control. But others find some tracker organs heavy to play, some tubular-pneumatic organs sluggish, and so prefer electro-pneumatic action. == Modern methods == In the years after the advent of the [[transistor]], and later, [[integrated circuit]]s and [[microprocessor]]s, miles of wiring and electro-pneumatic relays have given way to electronic and computerized control and relay systems, which have made the control of pipe organs much more efficient. But for its time, the electro-pneumatic action was considered a great success, and even today modernized versions of this action are used in many new pipe organs. == Sources == *[http://www.organworks.com/web/about/OrgHistory.asp A Brief History of Electronics in Pipe Organs] *Foort, Reginald, "The Cinema Organ," Second Edition, New York: The Vestral Press, 1970, pp 74-78. [[Category:Pipe organ components]]