Saltwater intrusion
1252844
221482391
2008-06-24T18:18:54Z
Alexnia
7199096
Reverted edits by [[Special:Contributions/216.79.175.118|216.79.175.118]] to last version by SmackBot (using [[WP:HG|Huggle]])
{{Refimprove|date=June 2008}}
'''Saltwater intrusion''' is a process that occurs in virtually all [[coast]]al [[aquifer]]s, where they are in [[hydraulic]] continuity with [[seawater]].
It consists in [[salt]] water (from the [[ocean|sea]]) flowing inland in freshwater aquifers. This behaviour is caused by the fact that sea water has a higher [[density]] (which is because it carries more solutes) than freshwater. This higher density has the effect that the [[pressure]] beneath a column of saltwater is larger than that beneath a column of the same height of freshwater. If these columns were connected at the bottom, then the pressure difference would trigger a flow from the saltwater column to the freshwater column.
The [[flow]] of saltwater inland is limited to coastal areas. Inland the freshwater column gets higher and the pressure at the bottom also gets higher. This compensates for the higher density of the saltwater column. Where this happens, saltwater intrusion stops.
The higher water levels inland have another effect: they trigger flow of freshwater seaward. This completes the picture: at the sea-land boundary, at the high part of the aquifer freshwater flows out and in the lower part, saltwater flows in. The saltwater intrusion forms a wedge.
[[Pumping]] of fresh water from an aquifer reduces the water pressure and intensifies the effect, drawing salt water into new areas. When freshwater levels drop, saltwater intrusion can proceed inland, reaching the pumped [[Water well|well]]. Then saltwater, unfit for [[potable water|drinking]] or [[irrigation]], is produced by the pump. To prevent this, more and more countries adopt extensive monitoring schemes and numerical [[Model (abstract)|models]] to assess how much water can be pumped without causing such effects.
The first physical formulations of saltwater intrusion were made by W. Badon-Ghijben (1888, 1889) and A. Herzberg (1901), thus called the Ghyben-Herzberg formulation. They derived analytical solutions to approximate the intrusion behaviour, which are based on a number of assumptions that do not hold in all field cases. The Ghyben-Herzberg ratio states, for every foot of fresh water in an unconfined aquifer above sea level, there will be forty feet of fresh water in the aquifer below sea level. In the 20th century the higher [[computer|computing]] power allowed the use of numerical methods (usually [[finite difference]]s or [[finite elements]]) that need less assumptions and can be applied more generally.
Even so the modelling of saltwater intrusion is considered difficult. Some typical difficulties that arise are:
* The possible presence of [[fissures]] and cracks and fractures in the aquifer, whose precise positions are unknown but which have great influence on the development of the saltwater intrusion
* The possible presence of small scale heterogeneities in the hydraulic properties of the aquifer, which are too small to be take into account by the model but which may also have great influence on the development of the saltwater intrusion
* The change of hydraulic properties by the saltwater intrusion. A mixture of saltwater and freshwater is often undersaturated with respect to calcium, triggering [[solvation|dissolution]] of calcium in the mixing zone and changing hydraulic properties.
* The process known as [[Ion exchange|cation exchange]], which slows the advance of a saltwater intrusion and also slows the retreat of a saltwater intrusion.
* The fact that saltwater intrusions are often not in equilibrium makes it harder to model. Aquifer dynamics tend to be slow and it takes the intrusion cone a long time to adapt to changes in pumping schemes, rainfall, etc. So the situation in the field can be significantly different from what would be expected based on the sea level, pumping scheme etc.
* For long-term models, the future [[climate change]] forms a large unknown. Model results often depend strongly on sea level and recharge rate. Both are expected to change in the future.
[[Image:Catfish Pond Control Structure.jpg|thumb|300px|A saltwater intrusion control structure (lock) on the Mermentau River in coastal Louisiana]]
Saltwater intrusion is also an issue where a [[Canal lock|lock]] separates salt water from fresh water (for example the [[Hiram M. Chittenden Locks]]). In this case a collection basin was built from which the salt water can be pumped back to the sea. Some of the intruding salt water is also pumped to the [[fish ladder]] to make it more attractive to migrating [[fish]].
==References==
{{Reflist}}
*{{cite book
| last =Goosen & Shayya
| first =
| authorlink =
| coauthors =Mattheus F. A. Goosen, Walid Hani Shayya
| title =Water Management, Purification & Conservation in Arid Climates
| publisher =CRC Press
| date =2000
| location =
| pages =
| url =http://books.google.com/books?id=90BTKFJStNoC&pg=PA135&dq=%22Saltwater+intrusion%22+Badon&as_brr=3&client=firefox-a&sig=8ELkspFfJZbQvt2GXVGLz1LuUQE#PPA134,M1
| doi =
| id = ISBN 1566767598 }}
[[Category:Aquifers]]
[[Category:Geology]]
[[Category:Hydrology]]
[[Category:Aquatic ecology]]
[[Category:Environmental issues]]
[[ca:Salinització]]